UIS Tester 1 (PD-Tester)Electronic simulator for Unit Injector System
Обзор
UIS Tester 1 (PD-Tester) Electronic simulator for Unit Injector System
Device “UIS-Tester 1” is intended to test and verify performance of pump-injector (UIS-Unit Injector System) and individual high-pressure fuel pump with high-pressure solenoid valves (UPS – Unit Pump System).
Device “UIS-Tester 1” allows you to:
• set a control signal of electromagnetic high pressure valve;
• measure the frequency of rotation of the cam shaft drive screw;
• set the required number of cycles;
• mode of presets, for 5 control modes of electromagnetic valve;
• set any value of the angle advance of the turning the electromagnetic valve on.
PD- Tester can be installed in the test bench, which is used to test the unit-injector of the fuel systems UIS and UPS. For this purpose it is necessary to equip the test bench with a mechanical device CAM-BOX1 or CAM-BOX2.
Specifications
| Supply voltage | ~ 220 В ±15%; |
| Value of a angle of a delay of a signal | 0 — 359° |
| Number of injections in a minute | 100-1500 |
| Weight | 8 kg |
| Dimentions (length x width x height) mm | 300х230х110 mm |
| Power consumption | до 350 Wt |