FLAGMAN-FLOW (MUFI-CR) Electronic measuring unit for CR-Tester FLAGMAN CRT-5040
Обзор
FLAGMAN-FLOW (MUFI-CR)
8-channel measuring unit for CR injectors, for CR Tester Flagman 5040
MUFI-CR. 8-channel measuring unit for CR injectors, for CR Tester Flagman 5040
The measuring unit is divided into 2 sections designed to measure the flow of test fluid through the injectors in the "flow" and "backflow" lines, respectively. Each section can measure the flow in 4 channels.
All connections for the flow and backflow of test fluid to the elements of the measuring unit are made through teflon tubes (Ø 6mm) using quick-release adapters. At the entrance to each meter is installed a sensor for the temperature of the incoming liquid. This temperature is displayed in the "CASCADE" software.
Technical data |
|
Number of simultaneously tested injectors | 4 |
Valve power in the injector measuring block | 24 V |
Test liquid temperature control | on each injector |
Number of measuring sensors in injector measuring unit | 2 |
Measuring speed of the measuring unit | 0,01 l/min-0,5 l/min |
Measurement error (cars) 0,15 mm3 -85 mm3 | no more than 1% |
Measurement error (trucks) 0,15 mm3 - 400 mm3 | no more than 1,5% |
Resolution of injector measuring unit | ~ 0,1 mm3 /1 cycle (injection) |
Set of delivery
Delivery set of FLAGMAN-FLOW (MUFI-CR)
Item Qty
Measuring unit without measuring tube FLAGMAN-MUFI-CR 1 pc
Manual (technical description, operating instructions) 1 pc
Set of connecting cables for the MUFI-CR measuring unit and the FLAGMAN controller 1 set
Compatible hardware and accessories
FLAGMAN CRT-5040 controller 1 pc
Vacuum creation system 1 set
Injection start measurement sensor 1 pc
Coding software DT-CODE DELPHI C2i, C3i
DT-CODE BOSCH coding software in development
DT-CODE DENSO coding software in development
Pressure accumulator for 1-3 regulators 1 pc
Pressure regulator for 1-3 pc 1-3 pcs
Pressure sensor 1 pc
Safety valve 1 pc
High pressure gauge 1 pc
Injector holder with bracket 1 pc