UIS Tester 2 Electronic simulator for Unit Injector System
Обзор
UIS Tester 2 Electronic simulator for unit injection system
Device “UIS-Tester 2” is intended to test and verify performance of pump-injector (UIS-Unit Injector System) and individual high-pressure fuel pump with high-pressure solenoid valves (UPS – Unit Pump System).
UIS- Tester2 can be installed in the test bench, which is used to test the unit-injector of the fuel systems UIS and UPS. For this purpose it is necessary to equip the test bench with a mechanical device CAM-BOX2.
Device “UIS-Tester 2” allows you to:
• set a control signal of electromagnetic high pressure valve;
• measure the frequency of rotation of the cam shaft drive screw;
• set the required number of cycles;
• mode of presets, for 5 control modes of electromagnetic valve;
• set any value of the angle advance of the turning the electromagnetic valve on.
Specifications
Supply voltage | ~ 220 V ±15%; |
Value of a angle of a delay of a signal | 0 — 359° |
Number of injections in a minute | 100-1500 |
Weight | 8 kg |
Dimentions (length x width x height) mm | 365 х 320 х 110 mm |
Power consumption | up to750 Wt |
Scope of delivery:
- Devise UIS-Tester
- software with test.plans of ВOSCH
- power cable
- speed sensor
- cablefor connection to speed sensor
- cable for connection to injectors of BOSCH 1 type
- cable for connection to injectors of BOSCH 2 type
- universal cablefor for connection to injectors
- reed switch
- connector for cable